Rocktron Cyborg Delay User Manual download pdf (Page 16)

Hold Function

The Hold function allows you to record a quick riff which you can then play over.

The HOLD function is only available on Preset 6. When you active preset 6 by

turning on the delay using the ON/OFF switch (point 10) the delay will function as

it would normally. Now, to activate the HOLD function follow these steps:

1) Play a riff until it is in time with the delay (note that the delay rate can be

changed by tapping the TAP/STORE button (point 9)).

2) Once you are in time, depress and hold down the TAP/STORE button (point 9)

until you hear the riff repeating.

3) Take your foot off of the TAP/STORE button and stop playing. You should now

hear the riff repeating automatically (or HOLDING) and the LED will be lit.

4) Now, before you start playing again, use the ON/OFF switch (point 10) to turn

off the delay. The riff will continue to play. You can now play or solo over the riff

without changing the riff.

5) You can then add more riffs (or layer more notes) over the playing riff by playing

along with the riff until you are in sync with it. While you are playing turn the ON/

OFF button (point 10) ON. Continue playing until you hear what you have just

played repeat. Using the ON/OFF button, turn the delay off. Now you should be

hearing both riffs playing at the same time. At this point you can jam over the

playing riffs.

6) You can continue to add riffs or layer notes over the playing riff by repeating

step 5.

7) To turn OFF the playing, riff or pattern press and release the TAP/STORE button

with your foot once, this will turn OFF the HOLD function and TAP/STORE LED

will blink at the delay rate and the riff/pattern will decay.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Rocktron Cyborg Delay User Manual Page 16