Rocktron Prophesy II User Manual download pdf (Page 50)

Reverb Page 1:

122

DESCRIPTION

The REVERB PAN parameter allows you to pan the direct input signal to the

reverb section to the left or right—thus allowing for only the left or right channel

to be reverberated when used with the Dual reverb type, or, for one channel to be

reverberated to a greater degree than the other. It is adjustable from LEFT (0) to

RIGHT (100), where 1-49 appear between LEFT and CENTER, and 51-99

appear between CENTER and RIGHT.

The REVERB DECAY parameter specifies the length of time that the reverb

signal will sound before it has completely "died out". Note that the maximum

length of this decay will vary dependent upon the reverb type currently active. (0

to 99)

The HIGH FREQUENCY DAMPING parameter is used to control the decay

rate of high frequency information in the reverb signal. Higher parameter settings

will result in a faster decay of high frequency information. (0 to 99)

The LOW FREQUENCY parameter determines the amount of low frequency

information in the reverb signal. Higher levels of this parameter add more low

end. (0 to 99)

The REVERB TYPE parameter determines the active reverb type. The following

types are available: Plate A, Plate B, Room A, Room B, Hall A, Hall B, Stadium

and Dual.

PARAMETER NAME

R-PAN

R-DEC

HFDMP

L-FRQ

REV TYPE

Reverb Page 1 parameters

L-FRQ

HFDMP

R-DEC

R-PAN

L<29

REVTYPE

HALL A

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

No comments

Rocktron Prophesy II User Manual Page 50