Rocktron Xpression Service Manual download pdf (Page 7)

3. Front Panel

1 POWER switch

2 PRESET control

This control scrolls through and instantly recalls the successive presets.

3 TAP (DELAY/RATE) button

This button is used to select a new delay time or modulation rate based on the length of

time occurring between two taps. See Section 7 (page 50): "Tap Delay" for more

information.

4 DISPLAY panel

The DISPLAY panel provides 16 characters consisting of 14 segments each.

5 COMPARE button

The COMPARE button may be used to compare an altered parameter value to its stored

value.

Note: If comparing an altered value to the stored value and the stored value

is currently being viewed, turning a knob or pressing a button that

changes the parameter value displayed will cancel the previous altered

value. This will also occur if a MIDI control change is received while

viewing the stored value(s).

6 PARAMETER ADJUST control

This control is used to adjust the displayed parameter value. When the parameter is

altered from its stored value, the LED above the STORE button will light until either (a)

the new value is stored, (b) a new preset is selected or (c) the parameter is returned to its

original value.

7 STORE button/led

This button is used to store parameter values into the Xpression

™

memory when altered.

See "Storing Changed Preset Parameters" in Chapter 7 (page 40) for more information

on this procedure.

8 PARAMETER SELECT control

When adjusting parameter values, this control will scroll through the available

parameters under the current function heading.

In the "Title Edit" function, this control will scroll through the character locations to be

edited.

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

No comments

Rocktron Xpression Service Manual Page 7