Rocktron Cyborg User Manual

SOLO/STORE - PRESET SELECT SWITCH and STORE LED - thisswitch has three functions:o SOLO Mode - Each preset of the Cyborg Distortion has two modes, Cr

Output Jack - Using a standard guitar cable with a 1/4” jack, plug into your amplifier or the next effect pedal in your signal chain.MIDI Jack - Using

BASIC OPERATIONThe Cyborg Distortion has 16 presets that are immediately available (with aMIDI Pedal you can access 128 presets).You will notice that

LED DisplayThe Cyborg’s LED Display consists of 8 LEDs that are used to visually show the user:1) The DISTORTION TYPE2) The PRESET selected (1-8)3)

GAIN and the LEDs will light from left (MIN) to right (MAX). To decrease the amount of GAIN turn the knob counter-clockwise and the LEDs will turn of

7) The MIDDLE Control KnobWhen the “2ND FUNCTION” switch is switched to the right, turning the MIDDLE control knob will light LEDs in the display to

Lets say you want to make a change to preset 1. Follow these steps (note thatyou can store the preset at anytime during this process).1) Turn the TYPE

HUSH® is Rocktron’s patented single-ended noise reduction system, and is available in all presets. The HUSH system provided in the Cyborg is a fully d

MIDIThe Cyborg Distortion pedal has a MIDI jack that allows you to access an addi-tional 112 user presets. Using the included Rocktron MIDI Breakout

MIDI - Connection 1

Copyright © 2007 GHS Corporation All Rights Reserved.Your Cyborg™ Digital Distortion pedal has been designed to comply with the fol-lowing Standards a

MIDI - Connection 2

SpecificationsMaximum InputInput ImpedanceCurrent ConsumptionFreq. ResponseDynamic RangePower RequirementsDimensions+3dBu1M Ohm1000mA20Hz-16KHz A-Weigh

Notes:

Notes:

Rocktron - A Division of GHS Corporation2813 Wilber Ave.Battle Creek MI 49015USARocktron Phone: 1-(269)-968-3351Email: [email protected]

Do not block any ventilation openings (if applicable). Install in accordance with the manufacturer’s instructions.Do not install near any heat source

IntroductionCongratulations on your purchase of the Rocktron Cy-borg Digital Distortion. The Cyborg Digital Distortion is one of a series of “Digi-tal

Connection 1 - Standard Connection

Descriptions

PRESET/HUSH Threshold Knob - this control knob has two functions. 1) This knob allows you to select the “preset” you desire. Eight presets are avai

GAIN/MIDDLE Knob - this knob has two functions:1) Allows you to select the amount of GAIN added to each preset. The Gain structure is different on e

In addition the 2nd Function switch must be to the right in order to store any changes you have made with the SOLO/Store Switch.Note: When the 2nd Fun