Rocktron MultiValve User Manual download pdf (Page 66)

Operating the MultiValve

Step 4

Press the STORE button at this time to initiate the All Restore procedure and erase all current

MultiValve presets, replacing them with the original factory presets. The MultiValve will

display "INITIALIZING" as the MultiValve memory is restored.

INITIALIZING

After the All Restore process is completed, the display should read "ERRORS 0". This is the

number of bytes that the MultiValve found that did not initialize properly. Any number of

errors other than "0" means that the MultiValve may not have initialized properly and the

process should be repeated.

ERRORS 0

The MultiValve will remain in this condition until the FUNCTION SELECT control is turned to

exit the Factory Restore function. The preset currently recalled will be the preset most recently

restored into the current location.

The controller assignments for the MultiValve can also be reinitialized without affecting

presets and other stored information. Reinitialization of the controller assignments is necessary

when setting up the MultiValve to operate in remote mode with a Rocktron All Access

footswitch.

To reinitialize only the controller assignments, enter a code number of "244" at Step 3 on

the preceding page (instead of the "243" shown).

Restoring the MultiValve controller assignments:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

No comments

Rocktron MultiValve User Manual Page 66