Rocktron MultiValve User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
6
4. Rear Panel
1 INPUT jack
This ¼" mono jack provides input to the MultiValve.
2 Left and Right OUTPUT jacks
These ¼" mono jacks provide outputs from the left and right channels of the MultiValve
.
3 Tap Delay/Rate FOOTSWITCH jack
This ¼" mono jack is provided for the connection of a momentary footswitch to control
the Tap Delay feature of the MultiValve
.
4 CHANNEL SWITCH jack
This ¼" stereo jack can be connected to the channel switching footswitch jack on an
amplifier or preamp. This allows for programmable channel switching directly from the
MultiValve
.
.
5 PHANTOM POWER jack
This 2.5mm PIN jack offers the ability to power Rocktron MIDI foot controllers from a 7-
pin MIDI cable which connects from the Rocktron MIDI foot controller to the MIDI IN
jack on the rear panel of the MultiValve
. This eliminates the need to find an AC outlet
near where the footpedal would be placed during a performance, or the need to run an
extension cord out to the footswitch. Instead of inserting the AC adaptor into the
"POWER" jack of the footswitch as you would normally, plug it into the "PHANTOM
POWER" jack on the MultiValve
. This will power the Rocktron MIDI foot controller
through pins 6 and 7 of the MIDI cable connecting the two units. A 7-pin MIDI cable
must be used and is available from your Rocktron dealer.
6 MIDI IN/REMOTE jack
This 7-pin DIN connector must be connected to the MIDI OUT jack of the transmitting
MIDI device via a standard MIDI cable, or to the MIDI THRU jack of the preceding MIDI
device (if the MultiValve
is within a chain of MIDI devices). Pins 6 and 7 of this
connector carry phantom power to power a Rocktron MIDI foot controller when a 7-pin
MIDI cable is used.
This connector is also provided for the connection of a Rocktron All Access
MIDI
footswitch, which can be configured as a dedicated remote footswitch for the
MultiValve
. This feature allows the user to access MultiValve
functions and parameters
via the remote footswitch.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Comments to this Manuals

No comments