Rocktron EN50082-1 User Manual download pdf (Page 22)

PITCH SHIFT

Pitch Shifting is used to change the pitch of the input signal to produce one to four

harmony notes based on a single input signal. The

Hush; Pitch Shift; Delay

configuration

offers 4 harmony voices while the

Hush; Pitch Shift; Delay; Reverb

configuration offers 2.

Each harmony voice may be of any fixed interval - from to one octave above the input signal

to two octaves below - and is selected in 20 cent increments. Increments of one cent (1/

100th of a semitone) are also available for fine adjustment via the Fine parameter.

Pitch Shift Parameters

Parameter Description

PITCH

The Pitch parameter determines the harmony note the Intellifex XL will

produce based on the input note. An interval is the distance in

semitones between the pitches of two musical tones (i.e. the distance

from an A note to a C note is considered a minor third interval, this

equals 3 half-steps or 300 cents). The Pitch parameter is adjustable in

20 cent increments and any interval may be selected from one octave

above to two octaves below the input signal. This parameter is adjust-

able from -2400 to +1200 - where -2400 = 2 octaves below the input

signal, 0 = unison and +1200 = one octave above the input signal. Each

100 cents (or 5 - 20 cent steps) above or below 0 represents the

amount of half-steps (or semitones) the harmony note will be above or

below the input signal.

FINE

The Fine parameter allows for fine adjustment of pitch change in 1 cent

steps (or 1/100th of a semitone) for finer adjustment of the harmony

note.

LEVEL

The Level parameter determines the volume of each voice relative to

the other voices of the effect. (This is not the same as the Pitch Shift

Level parameter found in the Mixer Function parameter list.)

PAN

This parameter allows you to pan the shifted note to the left or right

channel of the Intellifex XL. It is adjustable from 0 to 100, where 0 = full

left, 100 = full right and 50 = center.

DELAY

This parameter allows for the shifted signal to be delayed up to 1025mS

following the input signal. It is adjustable from 0 to 1025mS in 5mS

increments.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 57 58

No comments

Rocktron EN50082-1 User Manual Page 22