Rocktron EN50082-1 User Manual download pdf (Page 8)

1) R(MONO) INPUT jack:

This standard 1/4" mono jack provides input to the right channel of the Intellifex XL. When

using only one input (mono), this jack should be used.

2) L INPUT jack:

This standard 1/4" mono jack provides input to the left channel of the Intellifex XL. When

using only one input, this jack should not be used.

3) R OUTPUT jack:

This standard 1/4" mono jack provides an output for the right channel of the Intellifex XL.

When using the unit in a mono application, either output jack may be used.

4) L OUTPUT jack:

This standard 1/4" mono jack provides output for the left channel of the Intellifex XL. When

using the unit in a mono application, either output jack may be used.

5) PHANTOM POWER jack:

This jack offers the ability to power the Rocktron MIDI Mate

™

Foot Controller from a seven

pin MIDI cable which connects from the MIDI Mate to the MIDI IN jack on the rear panel

of the Intellifex XL, eliminating the need to find an AC outlet near where the footpedal

would be placed during a performance - or the need to run an extension cord out to the

MIDI Mate. Instead of inserting the adaptor into the MIDI Mate

™

POWER jack, plug it into

the PHANTOM POWER jack on the Intellifex XL. This will power the MIDI Mate

™

through pins 6 and 7 of the MIDI cable connecting the two units. A 7-pin MIDI cable must

be used and is available through your Rocktron dealer.

6) MIDI IN jack:

This 7-pin DIN connector receives MIDI information from the device which is transmitting

the MIDI commands for the Intellifex XL to execute.

7) MIDI OUT/THRU jack:

This standard 5-pin DIN connector passes on the MIDI information that is received at the

MIDI IN jack to other MlDI-compatible devices via a MIDI cable. It also outputs MIDI data

when performing a memory dump.

Note: Inherently in MIDI there is a limit to the number of devices which can be chained

together (series connected). With more than three devices, a slight distortion of the MIDI

signal can occur (due to signal degradation) which can cause an error in MIDI signal

transmission. Should this problem arise, a MIDI box can be used which connects directly to

the MIDI device which transmits MIDI information and has multiple connectors for the

multiple devices receiving MIDI. MIDI cables should not exceed 50 feet (15 meters) in

length.

8) POWER jack:

This jack accepts power from the 9VAC/1500mA adaptor supplied with the unit.

4. Rear Panel

Note

When using a mono input and a

mono output, the left and right

effect signals will be summed at

the single output.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Comments to this Manuals

No comments

Rocktron EN50082-1 User Manual Page 8

Comments to this Manuals

Related products and manuals for Tuner Rocktron EN50082-1